Table of Contents
Advertisement
4
Configuring Your ISDN
Line and Network
The set up procedure for the omni needs to be done only once. The
settings will be stored in non-volatile RAM. The only time you will
need to reconfigure your line is when you perform a hardware reset
on your TA or when you change options on your ISDN line.
If your TA is not going to be set up by a computer running Windows
3.x, 95, or NT4.0 you will need some type of terminal program that
allows you to send AT commands to the TA and receive responses
from the TA.
Configuring Your TA
Complete the following steps to configure your TA using the ZyXEL
Configuration Utility Disk:
1. Insert your ZyXEL Configuration Utility Disk into your
computers floppy drive.
2. From Windows 3.x choose Run... from the File menu.
3. From Windows NT4.0 choose Run... from the File menu.
4. From Windows 95 choose Run... from the Start menu.
5. Type: A:\setup.exe and press Enter.
6. Follow the instructions on your screen.
Configuring your TA using a Terminal
program
If you are not using the ISDN configuration utility that is packaged
with the omni, you will need a terminal program with which to
configure the unit. The TA should work with any asynchronous
Configuring Your ISDN Line and Network 21
Advertisement
Table of Contents
