Table of Contents
Advertisement
settings will be handled by your operating system if it supports the
Plug and Play standard.
If your operating system does not support Plug and Play, a DOS
configuration utility has been included on the floppy disk that is
included with your omni. To configure your omni internal card using
the disk follow the steps below:
1. Insert the floppy disk in the appropriate drive.
2. From the C prompt type a: and press Enter.
3. From the A prompt type instlpnp and press Enter.
4. The following message will appear:
Would you like to create the default
directory?
Press Y to continue.
5. The following message will appear:
Do you want to modify the autoexec.bat file?
Press Y to continue.
6. Press Alt-Ctrl-Delete to reboot your system.
7. The following message will appear:
Do you want to reconfigure your ZyXEL PnP
card?
If you press N installation is complete.
If you press Y you will see the screen below:
Installing omni Internal Models 17
Advertisement
Table of Contents
