Making V.110 Calls; Synchronous Connections (External) - ZyXEL Communications ACCESSING INTERNET & INTRANET omni series User Manual

will report "RING" to your terminal. External models will also make
an audible ring notification.

Making V.110 Calls

Before the ATDIxxx command is given to place the call, you need to
make sure that the TA is in asynchronous mode (AT&M0). Then use
the following commands to configure V.110:
AT Command
ATB10
ATB13
ATB14
ATB15
ATB16
ATB17
ATB18
ATB19
The highest Async V.110 user rate depends on bit 4 of S119 as
follows:
S119.4=0
S119.4=1
S119.4=1
If the DTE speed is higher than what has been set, the user rate on
above table will be used.

Synchronous Connections (external)

Use the following commands to choose the data rate for synchronous
operation :
ATB11
52 V.110 and Synchronous Mode Communications
Description
User rate follows DTE speed (see note below).
User rate = 2400bps.
User rate = 4800bps.
User rate = 9600bps.
User rate = 14400bps.
User rate = 19200bps.
User rate = 38400bps.
User rate = 57600bps (Japanese version only).
19200 bps.
38400 bps for areas other than Japan (default).
57600 bps for Japanese version.
64000bps