Bacp/Bap - ZyXEL Communications ACCESSING INTERNET & INTRANET omni series User Manual

ATJSn - Subtract traffic threshold for n K bits per second, n = 32
(default).
ATKAmn - Add persist time for n period in m unit, n = 0 - 127,
m = s for seconds and m for minutes.
ATKSmn - Subtract persist time for n period in m unit, n = 0 -
127, m = s for seconds and m for minutes.

BACP/BAP

Bandwidth Allocation Control Protocol and Bandwidth Allocation
Protocol is used for call request and link drop under Multilink PPP.
BACP is negotiated during the network phase. Without BACP/BAP,
the directory numbers of both B channels must be specified before
dialing out. In some cases, it is not possible for the ISP to support
more than one chassis that is capable of bundling both channels at the
same time. With BACP/BAP, the second B channel's directory
number can be obtained while requesting a call. The second directory
number is not necessary any more. The BACP/BAP is supported on
the client side only. The server side of BACP/BAP will be
implemented in an upcoming release.
Related commands:
ATBP0 - Disable BACP/BAP negotiation.
ATBP1 - Enable BACP/BAP negotiation (default).
: The status of BACP/BAP negotiation can' t be saved in profile. It' s
O
NOTE
enabled after power on. The status can be changed only by the
power cycle of another ATBP command. AT&F and ATZ doesn' t
change the status.
Point-to-Point Protocol (PPP) 49