ZyXEL Communications ACCESSING INTERNET & INTRANET omni series User Manual page 34

terminal program that can communicate directly with one of the
communication ports on your system. If you do not know how to use
a terminal program, refer to the instructions that came with the
terminal program.
Make sure the program is set up to communicate with the COM port
that the TA is connected to. You can check to see if the DTR LED is
on when the terminal program is active. In most cases, if the terminal
program is active and ready to communicate with the port that the
TA is connected to, it will activate the DTR signal. This will cause
the DTR LED to light up. If the DTR LED is not ON, you will need
to check the program's settings.
The communication speed can be set to anywhere between 2,400bps
and 460,800bps, but 115,200bps is a good default value. The TA will
automatically adjust its speed to match your communication speed.
Once the terminal communication program is ready, you can type a
simple command to see if the TA responds.
Type:
AT<Enter>
TA should respond:
OK
Type:
ATI<Enter>
TA should respond:
1281
Type:
ATI1<Enter>
TA should respond:
omni (model) USA: V 1.00a (Firmware version number)
7607 (Firmware checksum will change based on your firmware version)
OK
22 Configuring Your ISDN Line and Network