Configuring Ip; Figure 27 Ip Setup; Table 24 Ip Setup - ZyXEL Communications ZyXEL ZyAIR G-1000 User Manual

7.2 Configuring IP

Click ADVANCED and then IP to display the screen shown next.

Figure 27 IP Setup

The following table describes the labels in this screen.

Table 24 IP Setup

LABEL
IP Address Assignment
Get automatically from
DHCP
Use fixed IP address
IP Address
IP Subnet Mask
Gateway IP Address
Apply
Reset
Chapter 7 IP Screen
DESCRIPTION
Select this option if your G-1000 is using a dynamically assigned IP address
from a DHCP server each time.
Note: You must know the IP address assigned to the G-1000
(by the DHCP server) to access the G-1000 again.
Select this option if your G-1000 is using a static IP address. When you select
this option, fill in the fields below.
Enter the IP address of your G-1000 in dotted decimal notation.
Note: If you change the G-1000's IP address, you must use the
new IP address if you want to access the web configurator
again.
Type the subnet mask.
Type the IP address of the gateway. The gateway is an immediate neighbor
of your G-1000 that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your G-1000; over the
WAN, the gateway must be the IP address of one of the remote node.
Click Apply to save your changes back to the G-1000.
Click Reset to begin configuring this screen afresh.
G-1000 User's Guide
71