Configuring Time Setting; Figure 13 Time Setting; Table 11 Time Setting - ZyXEL Communications ZyXEL ZyAIR G-1000 User Manual

G-1000 User's Guide

5.4 Configuring Time Setting

To change your G-1000's time and date, click the SYSTEM link under ADVANCED and
then the Time Setting tab. The screen appears as shown. Use this screen to configure the G-
1000's time based on your local time zone.

Figure 13 Time Setting

The following table describes the labels in this screen.

Table 11 Time Setting

LABEL
Time Protocol
Time Server Address
Current Time
(hh:mm:ss)
New Time (hh:mm:ss) This field displays the last updated time from the time server.
48
DESCRIPTION
Select the time service protocol that your time server sends when you turn on
the G-1000. Not all time servers support all protocols, so you may have to
check with your ISP/network administrator or use trial and error to find a
protocol that works.
The main difference between them is the format.
Daytime (RFC 867) format is day/month/year/time zone of the server.
Time (RFC 868) format displays a 4-byte integer giving the total number of
seconds since 1970/1/1 at 0:0:0.
The default, NTP (RFC 1305), is similar to Time (RFC 868).
Select None to enter the time and date manually.
Enter the IP address or the URL of your time server. Check with your ISP/
network administrator if you are unsure of this information.
This field displays the time of your G-1000.
Each time you reload this page, the G-1000 synchronizes the time with the
time server.
When you select None in the Time Protocol field, enter the new time in this
field and then click Apply.
Chapter 5 System Screens