Chapter 11 Introducing The Smt; Connect To Your G-1000 Using Telnet; Changing The System Password; Figure 49 Login Screen - ZyXEL Communications ZyXEL ZyAIR G-1000 User Manual

G-1000 User's Guide
This chapter describes how to access the SMT and provides an overview of its menus

11.1 Connect to your G-1000 Using Telnet

The following procedure details how to telnet into your G-1000.
1 In Windows, click Start (usually in the bottom left corner), Run and then type "telnet
192.168.1.2" (the default IP address) and click OK.
2 For your first login, enter the default password "1234". As you type the password, the
screen displays an asterisk "*" for each character you type.

Figure 49 Login Screen

3 After entering the password you will see the main menu.
Please note that if there is no activity for longer than five minutes (default timeout period)
after you log in, your G-1000 will automatically log you out. You will then have to telnet into
the G-1000 again. You can use the web configurator or the CI commands to change the
inactivity time out period.

11.2 Changing the System Password

Change the G-1000 default password by following the steps shown next.
1 From the main menu, enter 23 to display Menu 23 – System Security.
2 Enter 1 to display Menu 23.1 – System Security – Change Password as shown next.
3 Type your existing system password in the Old Password field, and press [ENTER].
94
Introducing the SMT
Password : xxxx
C
H A P T E R

Chapter 11 Introducing the SMT

11
.