Configuring Password; Figure 12 Password; Table 10 Password - ZyXEL Communications ZyXEL ZyAIR G-1000 User Manual

Table 9 System General Setup
LABEL
First DNS Server
Second DNS Server
Third DNS Server
Apply
Reset

5.3 Configuring Password

To change your G-1000's password (recommended), click the SYSTEM link under
ADVANCED and then the Password tab. The screen appears as shown. This screen allows
you to change the G-1000's password.
If you forget your password (or the G-1000 IP address), you will need to reset the G-1000. See
the Resetting the G-1000

Figure 12 Password.

The following table describes the labels in this screen.

Table 10 Password

LABEL
Old Password
New Password
Retype to Confirm
Apply
Reset
Chapter 5 System Screens
DESCRIPTION
Select From DHCP if your DHCP server dynamically assigns DNS server
information (and the G-1000's Ethernet IP address). The field to the right
displays the (read-only) DNS server IP address that the DHCP assigns.
Select User-Defined if you have the IP address of a DNS server. Enter the
DNS server's IP address in the field to the right. If you chose User-Defined, but
leave the IP address set to 0.0.0.0, User-Defined changes to None after you
click Apply. If you set a second choice to User-Defined, and enter the same IP
address, the second User-Defined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. If you do not
configure a DNS server, you must know the IP address of a machine in order to
access it.
The default setting is None.
Click Apply to save your changes back to the G-1000.
Click Reset to reload the previous configuration for this screen.
section for details
DESCRIPTIONS
Type in your existing system password (1234 is the default password).
Type your new system password (up to 31 characters). Note that as you type a
password, the screen displays an asterisk (*) for each character you type.
Retype your new system password for confirmation.
Click Apply to save your changes back to the G-1000.
Click Reset to reload the previous configuration for this screen.
G-1000 User's Guide
47