Authentication Required: Wpa2; Figure 23 Wireless Lan: 802.1X/Wpa For Wpa-Psk Protocol; Table 19 Wireless Lan: 802.1X/Wpa For Wpa-Psk Protocol - ZyXEL Communications ZyXEL ZyAIR G-1000 User Manual

G-1000 User's Guide

Figure 23 Wireless LAN: 802.1x/WPA for WPA-PSK Protocol

The following table describes the labels not previously discussed

Table 19 Wireless LAN: 802.1x/WPA for WPA-PSK Protocol

LABEL
Key Management
Protocol
Pre-Shared Key
WPA Group Key
Update Timer
Apply
Reset

6.7.4 Authentication Required: WPA2

Select Authentication Required in the Wireless Port Control field and WPA2 in the Key
Management Protocol field to display the next screen.
66
DESCRIPTION
Choose WPA-PSK in this field.
The encryption mechanisms used for WPA and WPA-PSK are the same. The only
difference between the two is that WPA-PSK uses a simple common password,
instead of user-specific credentials.
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including
spaces and symbols).
The WPA Group Key Update Timer is the rate at which the AP (if using WPA-
PSK key management) or RADIUS server (if using WPA key management) sends
a new group key out to all clients. The re-keying process is the WPA equivalent of
automatically changing the WEP key for an AP and all stations in a WLAN on a
periodic basis. Setting of the WPA Group Key Update Timer is also supported in
WPA-PSK mode. The G-1000 default is 1800 seconds (30 minutes).
Click Apply to save your changes back to the G-1000.
Click Reset to begin configuring this screen afresh.
Chapter 6 Wireless LAN