Remote Management And Nat; System Timeout; Configuring Www; Figure 28 Remote Management: Www - ZyXEL Communications ZyXEL ZyAIR G-1000 User Manual

8.1.2 Remote Management and NAT

When NAT is enabled:
• Use the G-1000's WLAN IP address when configuring from the WLAN.
• Use the G-1000's LAN IP address when configuring from the LAN.

8.1.3 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds).
The G-1000 automatically logs you out if the management session remains idle for longer than
this timeout period. The management session does not time out when a statistics screen is
polling. You can change the timeout period in the System screen

8.2 Configuring WWW

To change your G-1000's World Wide Web settings, click REMOTE MGMT to display the
WWW screen.

Figure 28 Remote Management: WWW

The following table describes the labels in this screen.

Table 25 Remote Management: WWW

LABEL
WWW
Server Port
Server Access
Secured Client IP
Address
Chapter 8 Remote Management Screens
DESCRIPTION
You may change the server port number for a service, if needed; however, you
must use the same port number in order to use this service for remote
management.
Select the interface(s) through which a computer may access the G-1000 using this
service.
A secured client is a "trusted" computer that is allowed to communicate with the G-
1000 using this service.
Select All to allow any computer to access the G-1000 using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the G-1000 using this service.
G-1000 User's Guide
73