List Of Professional Settings - Kyocera TASKalfa Pro 15000c Advanced Operation Manual

Appendix > List of Professional Settings

List of Professional Settings

No.
000 Output Maintenance Report
023 Reset Settings
034 Adjust Paper Timing Data
059 Set Fan Mode
208 Set Deck Paper Size
246 Adjust Finisher
251 Clear Maintenance Counter
327 Set Cassette Heater Control
407 Adj. Write Timing(Reverse)
460 Adjust Conveying Sensor
468 Color Regist Adj. Data
700 Head Information
730 Set Head Cleaning
731 Set Decurler
733 Set Warm Up Mode
734 Set Paper Discharge Mode
735 Set Ink Temperature Control
736 Set Waste Paper
744 Set Head Cleaning
750 Set Head Coefficient
754 Adjust Discharge Width
755 Adjust Conveying CIS
760 Set Color Bleeding
917 Read/Write Backup Data
Item
Print maintenance reports and status pages.
The adjustment setting value is restored to the factory default.
Adjust the tip edge timing and center line of paper.
Adjust the air flow of the drying conveyance fan motor according
to the paper type.
Configure the paper size to be loaded in cassettes 3 and 4.
Adjust various setting values when using a 4,000-sheet finisher,
Inverter and Decurler Unit, and 5,000-sheet stacker.
Clear the counter value after replacing parts when the print image
reached 600,000.
Switch the control mode of optional cassette heater integrated in
the machine.
Adjust the writing timing of the back surface image drawing
position at duplex copying.
Adjust the double feed sensor threshold of the machine's
conveying sensor.
Adjust the print head position of each color or the color drift.
Displays the print head temperature.
Configure the purge strength and execution interval of head
cleaning.
Adjust the fan control of the decurl unit for the machine and the
Inverter Decurler Unit (DE-9100).
Configure the print head protection or the heater operation
control of the Inverter and Decurler Unit (DE-9100), during warm-
up operation.
Set whether to enable the discharge mode or print the wasted
paper.
Adjust the printable ink temperature at Print Priority setting.
Specify the timing of ink discharge.
Perform a stronger level of head cleaning than the settings in the
system menu to eliminate print head failure.
Fine-tune the image density by adjusting the print head drive
voltage.
Adjust the width alignment cursor position to the paper width.
Perform CIS position correction (center and side).
Adjust the gap between colors when blur or void occurs in the
color boundaries.
Back up (export) the user Paper Catalog configured in the
machine and import it for use in another machine.
Description
5-2