Front/Back Position Shift - Kyocera TASKalfa Pro 15000c Advanced Operation Manual

Troubleshooting > Troubleshooting When Printing Image
2
3

Front/Back position shift

A
Bad
1
2
3
6
Select an item.
Select [01 Main Scan] or [02 Sub Scan].
7
Change the value using the [+], [-] keys or the numeric keypad.
Select the values (0-9, A-I) read from the chart, enter the appropriate value.
8
Press the [Start] key > [Stop] key.
The entered value is reflected.
9
In case that no improvement is observed, then go to next step.
Paper load check
Loading Paper (Chapter 7) in Operation Guide
In case that no improvement is observed, then go to next step.
Clean the feed roller or retard roller
Slip with dirty roller.
1
Check dirt on the rollers and clean up dirty parts.
Parts Cleaning (page 3-2)
2
In case that no improvement is observed, contact our service representative.
A
Good
Check paper
"Troubleshooting When Printing Image" > "Front/Back position shift" (Chapter 19) in
Operation Guide
In case that no improvement is observed, then go to next step.
Paper load check
Loading Paper (Chapter 7) in Operation Guide
In case that no improvement is observed, then go to next step.
Check the print zoom.
1
If you are using Fiery Controller, adjust the print zoom of the second side (back side) in
increments of 0.1%.
Printing System 50 user guides
You can download the user guide from the URL below.
https://services.efi.com/support/vfigs/3784295173/default.aspx
4-24