Troubleshooting > Troubleshooting When Feeding Paper
13
14
15
16
17
18
CAUTION
4 pins [F] on rails have to align with each 2 holes [D] and [E] in frame of image
conveying unit. (Pay attention the alignment otherwise the unit may drop.)
[E]
[F]
Push the Image conveying unit into the machine, and fasten it
with four screws
Close the Front Cover 1 and 2
Turn on the power switch
Attention LED on the operation panel lit.
[Home] key > [...] > [Professional Settings] > [U740 Setup] > [06
Feed Belt] > [02 Execute] > [Start] key
When "MANU0701" appears on [01 STEP], [02 Execute] >
[Start] key
When "AUTO0702" appears on [01 STEP], [02 Execute] > [Start]
key
The image conveying belt moves to the original position, and head cleaning starts.
It will take approximately five minutes to complete the head cleaning.
Other errors may occur during processing depending on the status of the machine. If an error
code is displayed, refer to the table below to clear the error.
4-48
[D]
[F]