Kyocera TASKalfa Pro 15000c Advanced Operation Manual page 20

Daily Management and Maintenance > Improving and maintaining of print quality
6
7
8
9
10
11
Measure the length from the leading edge of the chart to the
line of the image with a ruler.
Press [System Menu/Counter] or [Stop] key
Enter the value obtained by subtracting 20 from the value
measured in step 6 in [1st side] or [2nd side] using [+], [-] or the
numeric keys > [Start] key
The range of the set value is as follows.
Item
Start Position
[Stop] key > [Close]
[U034 Adjust Paper Timing Data] was configured.
Go to next step to adjust the center position of image sensor.
Load A4 or Letter size paper in cassette 1
[Home] key > [...] > [Professional Settings] > [U755 Adjust
Conveying CIS] > [01 Center Pos Adj] > [02 Print] > [Start] key
The front side chart is printed.
Range Default
-3.00 to 3.00
2-7
Amount of change
- 0.1 mm