Installing The Usb Streaming Audio Driver; Menu Walkthrough; Roomperfect; Voicing - Lyngdorf Audio TDAI-2170 Owner's Manual

Table of Contents

Room measurements above 90% RoomKnowledge

When RoomKnowledge has reached 90%, you can decide to add more room measurements or to do it at a later time. We recommend taking a couple

of measurements within 50cm/1.5ft of the walls and ceiling when above 90% RoomKnowledge

To fully optimize RoomPerfect™'s understanding of the room's acoustical properties, we recommend you keep doing measurements until the

RoomKnowledge is above 95%. The higher the RoomKnowledge, the more accurate the room correction filters will be.

Calculation of focus and global filters

When room measurements are complete, the TDAI-2170 will calculate the focus and global filters automatically.

0.5 m / 1.5ft

Installing the USB streaming audio driver

To stream audio from a Windows PC to the TDAI-2170, you need to install the Windows driver. The driver can be found on Lyngdorf.com.

Mac and Linux users do not need to install any drivers to stream audio to the TDAI-2170.

Using the USB streaming audio input

To stream music to the TDAI-2170, connect it to your computer via a USB cable.

Select "USB" as input on the TDAI-2170 and start playing music on your computer.

Selects between the available focus and global RoomPerfect™ filters.

Toggles between the available voicings, which adjusts the sound to your liking.

Select to toggle between speaker setup 1 and 2.

Note: Only active if enabled in Advanced Setting -> 2nd speaker setup.

In general, the settings in these sub-menus are specifically for the current active input.

Note: We recommend setting the output of a CD-player to 44.1 kHz. The TDAI-2170 will then get the original signal from the disc,

which allows for ICC (Intersample Clipping Correction) to function.

Min.

0.5m /

1.5ft

1m /

3ft

Table of Contents