Technical Specifi Cations; Audio - Lyngdorf Audio SDAI 2175 Owner's Manual

Technical specifi cations

Audio

Parameter
Balanced input connectors
Balanced input impedance
Balanced input CMRR
Unbalanced input connectors
Unbalanced input impedance
Tape Out output impedance
Pre Out output impedance
Max. input voltage
Input sensitivity
Voltage gain
Output connectors
Output power, 8ohms
Output power, 4ohms
Nominal load impedance
Frequency response
Frequency response
Frequency response
Output impedance
Output impedance
THD+N, 1W/8ohms
THD+N, 1W/4ohms
THD+N, 100W/8ohms
THD+N, 180W/8ohms
THD+N, 375W/4ohms
S/N ratio
Channel separation
Peak output current
Output common mode voltage
Output DC voltage
All audio measurements, except frequency response, are measured with a 20 kHz low-pass fi lter in ac-
cordance with AES-17.
16
Value
3 pin XLR, gold-plated.
10kOhm
40dB
RCA (phono) jack, gold-plated.
100kOhm
75 Ohm
75 Ohm unbalanced
100 Ohm balanced
±12Vp AC, 0-20V DC.
2V (1V with high sens.)
26dB
4 insulated binding posts, gold-
plated.
2*200W
2*375W
4 Ohms-8 Ohms
0.3Hz-33kHz
-0dB/+0.2dB
-0.2dB/+0dB
0.035 Ohms
0.4 Ohms
0.004%
0.006%
0.01%
0.07%
0.07%
113dB
84dB
±40A
35V DC
±5 mV
Note
Case=Gnd, Pin1=Gnd,
Pin2=Hot(+), Pin3=Cold(-)
AC-coupled.
20Hz-20kHz.
Case=Gnd, Tip=Hot(+)
AC-coupled
Gain 0 dB ref. active input
Gain According to volume con-
trol setting. 88 dB = 0 dB with
sensitivity 0 dB and rel. volume
0 dB
200W/8ohms
Will accept bare wire ends of up
to 5 mm diameter.
1KHz, 1% THD+N
1KHz, 1% THD+N
It is safe to operate the amplifi er
with no load.
-3dB points, 8ohms load.
20Hz-20kHz, 8ohms load
20Hz-20kHz, 4ohms load
20Hz-1kHz
20kHz
A-wgt.
A-wgt.
A-wgt.
A-wgt.
A-wgt.
A-wgt. Ref. 200W/8ohms.
1kHz, 200W/8ohms.
Ref. Ground. The amplifi er can
not be used in bridged mono
mode.