Table of Contents
Advertisement
Installing the USB streaming audio driver
To stream audio from a Windows PC to the TDAI-1120, you need to install a dedicated Windows drivers
(includes ASIO driver), which will ensure correct operation and optimal performance. The driver can be found
on Lyngdorf.com. Mac and Linux users do not need to install any drivers to stream audio to the TDAI-1120.
Using the USB streaming audio input
To stream music to the TDAI-1120, connect it to your computer via a USB cable.
Select "USB" as input on the TDAI-1120 and start playing music on your computer.
Information on Lyngdorf front panel logo
The LYNGDORF front panel logo is blinking in the following situations:
-
When the TDAI-1120 is starting after mains has been disconnected.
-
When the TDAI-1120 is executing a firmware update.
-
When the device is going in and out of deep sleep standby state.
In all of these situations user operatin is not possible.
Note: If for some reason the device should be stuck in an "animating logo situation" for
more than 10 minutes a power-cycle executed by removing the mains power supply to
FAQ and recommendations
When do I need to do a new RoomPerfect™ calibration?
If you change the position of speakers, the crossover settings or if you change your furniture position or type,
you need to do a new calibration, as these changes have an impact on the room acoustics.
What should I set my CD-players sample rate output to?
44.1 kHz. This will allow the ICC feature of the TDAI-1120 to avoid clipping of the signal.
My remote control (optional accessory) does not work properly
Press the "AMP" button to enable the remote control to operate the TDAI-1120 amplifier.
The multifunction remote control can operate several Lyngdorf Audio products.
Check the batteries.
Lyngdorf Audio TDAI-1120 – Owner's manual
the device might be required.
26
Hide quick links:
Advertisement
Table of Contents
