Figure 25 Wireless Lan; Table 12 Wireless Lan Setup Wizard 1; Table 13 Wireless Lan Setup Wizard 2 - ZyXEL Communications Network Device P-2602 User Manual

P-2602H(W)(L)-DxA Series User's Guide
The following table describes the labels in this screen.

Table 12 Wireless LAN Setup Wizard 1

LABEL
Active
Enable OTIST
Setup Key
Back
Next
Exit
3 Configure your wireless settings in this screen. Click Next.

Figure 25 Wireless LAN

The following table describes the labels in this screen.

Table 13 Wireless LAN Setup Wizard 2

LABEL
Network
Name(SSID)
Channel
Selection
66
DESCRIPTION
Select the check box to turn on the wireless LAN.
Select the check box to enable OTIST if you want to transfer your ZyXEL
Device's SSID and WEP or WPA-PSK security settings to wireless clients that
support OTIST and are within transmission range.
You must also activate and start OTIST on the wireless client at the same time.
The process takes three minutes to complete.
Type an OTIST Setup Key of up to eight ASCII characters in length. Be sure to
use the same OTIST Setup Key on the ZyXEL Device and wireless clients.
Click Back to display the previous screen.
Click Next to proceed to the next screen.
Click Exit to close the wizard screen without saving.
DESCRIPTION
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless
LAN.
If you change this field on the ZyXEL Device, make sure all wireless stations use the
same SSID in order to access the network.
The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a
channel. Select a channel ID that is not already in use by a neighboring device.
Chapter 3 Internet and Wireless Setup Wizard