Table of Contents
Advertisement
Duct Mount 285 Annubar
3. Push the flange and gasket flush against the duct wall; align the flow arrow in the
direction of flow and fasten the flange to the duct using the #12 sheet metal screws
provided.
Figure 5.
STUD
STUD
4. On the opposite side of the duct, place the
5
the
/
nut, and tighten. Depending on the pressure in the duct, it may be necessary to
16
add some high temperature gasket sealant where the stud protrudes through the duct
wall.
DUCT
STUD
NUT
LOCK WASHER
Duct Mount With Compression Fitting (Annubar type D2)
1. Place gasket against the mounting flange. Alternatively, a high-temperature gasket
sealant may be used.
2. Push the flange and gasket flush against the duct wall, and fasten the flange to the duct
using the #12 sheet metal screws provided.
6
1/4" SHEET METAL SCREWS
1/4" SHEET
METAL SCREWS
5
/
-in. lock washer over the stud, screw on
16
DUCT
STUD
NUT
ANNUBAR
Quick Installation Guide
00825-0100-4031, Rev AA
LOCK WASHER
April 2005
ANNUBAR
Advertisement
Table of Contents
