Change Code; Manager (01), Users (02-49) And Override User (50-59); Users Management; Lock Setup - Tecnosicurezza MiniTech User Instructions

Change code

Manager (01), users (02-49) and override user (50-59)

Power up the keypad. Press and hold
message:
Enter the old code and the Dallas key (if set).
Enter the new code and the Dallas key (if set).
Confirm the new code and the Dallas key (if set).
Test your new code several times before to close the secure storage unit's door.

Users management

Power up the keypad. Press and hold
message:
Enter Manager code.
Press to scroll users list or enter user ID.
"V" user installed, "_" user deleted, "X" user disabled.
Users 02-49 open with time delay (if set). Override user 50-59 opens without time delay. Override
users 50-59 can be only installed when lock is open. Open the lock before install the user.
Press . If the user is not installed LCD will display the message:
" " code, " " Dallas key, "+" dual mode, "TL" time lock
Press to confirm or press

Lock setup

Lock setup can be performed in two different ways only when the lock is in pre-setup, through a
setup Dallas key or directly thorough a PC connected to the keypad.
Page 6 of 20
(always perform this operation with door open)
to disable/enable/delete and press
. LCD will display the
. LCD will display the
ENTER OLD CODE
X X – X X X X X X
ENTER NEW CODE
X X X X X X
CONFIRM CODE
X X X X X X
USERS MANAGEMENT
0 1 – X X X X X X
02 03 04 05 06
v x _ _ v
02
INSTALL?
to confirm.
IU_MiniTech_03