Changing The Display From Meters To Feet - Fluke MicroScanner Pro User Manual

If you know a cable's NVP, change the displayed
numbers using the
NVP is displayed. The cable length will automatically
adjust to the new NVP.
If you know a cable's length, change the shown NVP
using the keys until the appropriate length is
displayed. The NVP can be adjusted in 1% increments,
and the length changes accordingly.
Cables used for calibration must be at least 50 feet (15
meters) long. Cable lengths of less than 50 feet will
display FAULT.
keys until the appropriate

Changing the Display from Meters to Feet

During Calibration you will be able to switch the
displayed length from meters to feet by simply pressing
the MODE key.
Press the ON/OFF key once the desired cable length or
NVP is displayed to terminate Calibrate mode and store
the new calibration factor. M
for future length measurements until another
calibration is performed.
MicroScanner Pro™
Calibration Mode
S P will use it
ICRO CANNER RO
7