Bosch TCA640 Series Repair Instruction page 79

7.4.3 Installing the software
Insert Start disk in drive "A"
Insert software CD in drive
Menu Start, Run, disk drive SETUP.EXE
Follow installation instructions
Start the programme
7.4.4 Connecting the test object
Data can be exchanged between the appliance to be tested and the
connected PC via the scanner.
The scanner is connected to the PC and test object with the
connecting cables included in the diagnostic kit. The scanner is
supplied with a 9 VAC operating voltage via the power supply unit.
58300000120060_ARA_en_c.doc – 18.09.09
7.4.5 USB service diagnosis kit
The scope of delivery is changed with the introduction of the new USB
service diagnostic kit (Mat.-no. 34 0995).
The power supply unit is no longer required because the scanner is
supplied via the USB connection on the PC.
Installation of the software, surface of the animation and diagnostic
sequence remain unchanged up to the present version.
Seite 79 von 95