Table of Contents
Advertisement
PD-TaD 80
I
Instructions for the operator • 9
Intended use • 9
L
Lifting and carrying the transport
cases • 31
M
Maintenance • 60
Malfunction and error messages • 63
Managing measurements • 29
Markings on the PD-TaD 80 • 26
Mounting bracket • 25
N
Near end (connection point) • 68
Note on the screenshots and
graphics used • 8
O
Operating states • 28
Operating the PD-TaD 80 • 28
P
Partial discharge (PD) • 68
Partial discharge measurement • 52,
68
PD-TaD • 16
Points to note during connection • 34
Power Box (PD-TaD 80 as a
standalone system) • 18
Power over Ethernet (PoE) • 69
Power supply • 25
Preparing a measurement • 51
Preparing the test object terminals •
32
Prerequisites • 35, 37, 40, 44
Procedure • 35, 38, 41, 44
Product information • 14
Putting the testing system out of
operation • 59
822-188-3
R
Replacing the calibrator battery • 62
Replacing the device protection fuses
in the Power Box • 61
Required equipment • 35, 38, 40, 44
S
Securing the PD-TaD 80 to the cross
beam • 33
Securing the test area • 50
Selecting a cable route and entering
cable data • 51
Setting up the system • 32
Special maintenance instructions •
60
Special personal protective
equipment • 13
Specific safety instructions • 30
Stability of the dissipation factor • 69
Storage • 65
Structure of safety instructions • 6
Switching off the system following
faults or in emergencies • 29
Switching on the system • 28
Switching on the system and starting
the BAUR software • 51
System • 69
T
Technical data • 27
Transportation • 64
Transportation and storage • 64
U
Use of the anti-corona protection • 34
Using this manual • 6
V
View Settings • 7
VLF cable testing with parallel partial
discharge testing • 54
VLF cable testing with parallel PD
test • 69
Index
71 / 74
Advertisement
Table of Contents
