Connection Cables - Baur PD-TaD 80 User Manual

Product information
3.6.2

Connection cables

PD-TaD 80 integrated in the cable test van
Figure
For the PD testing:
For the dissipation factor measurement:
22 / 74
Cable
Protective earthing cable
Cross section: 16 mm 2
HV connection cables
(2 pcs)
PoE cable (on hand
cable drum)
Calibrator connection
cables
tan-δ cable (on hand
cable drum)
VSE cables with 2
connection clips
(2 pcs)
VSE cables with Ø 4 mm
connector and a
connection clip
(2 pcs)
Length Function
1.5 m Is used to connect the PD-TaD to the protective earth
0.7 m / Are used to connect the PD-TaD to the test object
1.2 m
50 m / Is used for the supply of power to the PD-TaD and for
80 m data transmission
Used to connect the calibrator to the PD test circuit
50 m / Is used for data transmission during dissipation factor
80 m measurements
1.5 m Are used for the connection between the phases to be
tested at the far end (on the protective ring) and the
adjacent de-energised phase for the return of leakage
currents
3 m Is used for connections at the near end:

between PD-TaD and the phase to be tested (on
the protective ring)

between PD-TaD and the adjacent de-energised
phase for the return of leakage currents
PD-TaD 80
822-188-3