Replacing The Calibrator Battery; Accessories And Spare Parts - Baur PD-TaD 80 User Manual

Maintenance
14.4

Replacing the calibrator battery

NOTICE
Material damage may be caused by the wrong polarity of the battery
Wrong polarity of the battery can damage the electronics.
 When inserting batteries, pay attention to the polarity of the battery.
Prerequisites
Procedure
1. Switch off the calibrator with the On/Off switch.
2. Loosen the screws in the corners on the front side of the housing and open the calibrator
housing.
3. Remove the old batteries.
4. Insert new batteries.
5. Close the calibrator housing and screw it tight.
6. Dispose of the old batteries in compliance with the local regulations.
14.5

Accessories and spare parts

 Only use accessories and original spare parts recommended by BAUR.
 Only use the supplied connection cables or cable of the same specification.
PoE cable: If it is necessary to replace the PoE cable for connecting the Power Box and
the PD-TaD 80, use a standard commercially available Ethernet cable of category 5.
 Order accessories and spare parts from your nearest BAUR representative
(http://www.baur.eu/baur-worldwide).
62 / 74
Phillips screwdriver (size 2)
Battery type: 9 V block battery, DIN/IEC 6F22
PD-TaD 80
822-188-3