Securing The Pd-Tad 80 To The Cross Beam - Baur PD-TaD 80 User Manual

PD-TaD 80
6.6.1

Securing the PD-TaD 80 to the cross beam

If the connection point is located on a pole for example, it may be necessary to attach the
PD-TaD 80 to a cross beam or a comparable sub-structure.
Prerequisite
Procedure
The following illustration demonstrates an example for attaching the PD-TaD 80 to a cross
beam.
1. Loosen and remove the 5 screws on the underside of the PD-TaD 80.
2. Screw the mounting bracket to the PD-TaD 80 using the 5 screws (see Fig.).
3. Repeat steps 1 to 2 on the opposite side of the PD-TaD 80.
4. Place the PD-TaD 80 on the cross beam.
5. Guide the tension belts through the recesses located on both sides of the mounting
brackets and fasten the PD-TaD 80 on both sides with the tension belts.
6. Tighten the tension belts and check the stability of the PD-TaD 80.
Ensure that the tension lock is located below the device.
822-188-3
Offset screwdriver for Torx® screws, size TX 25 / 67 x 25 mm
Connecting the system
33 / 74