Advertisement
Instructions
•
When the door hinge is on the extension line of the actuator
mounting surface:
Door Hinge
(48.2)
Actuator Angle Adjustment
•
Using the angle adjustment screw, the actuator angle can be
adjusted (refer to the dimensional drawing on page 709).
Adjustable angle: 0 to 20°
•
The larger the adjusted angle of the actuator, the smaller the
applicable radius of the door opening.
•
After installing the actuator, open the door. Then adjust the
actuator so that its edge can be inserted properly into the
actuator entry slot of the interlock switch.
•
After adjusting the actuator angle, apply Loctite to the
adjustment screw so that the screw will not move.
When using the HS9Z-A53 Angle Adjustable
(vertical) Actuator
•
When the door hinge is on the extension line of the interlock
switch surface: 50 mm
•
When the door hinge is on the extension line of the actuator
mounting surface: 80 mm
Door
Hinge
(36.2)
When using the HS9Z-A55 Angle Adjustable
(vertical/horizontal) Actuator
•
When the door hinge is on the extension line of the interlock
switch surface: 50 mm
Horizontal Swing
Door
Hinge
(36.2)
•
When the door hinge is on the extension line of the actuator
mounting surface: 70 mm
Horizontal Swing
Door Hinge
(55.5)
HS5E Miniature Interlock Switches with Solenoid
Interlock Switch
Mounting Holes
Door Hinge
(47)
Door Hinge
(56.5)
Vertical Swing
Door
Hinge
(36.2)
Vertical Swing
Door Hinge
(55.5)
Mounting Examples
Application on Sliding Doors
Door
HS9Z-A51
Actuator
HS5E
Interlock
Switch
Latch
Door Stop
Application of Hinged Doors
HS9Z-A52 Actuator
HS5E
Interlock Switch
Installing the Head
Do not use the plastic and metal head of he HS5B interlock
switches on the HS5E. The metal heads of the HS5E and
HS5B interlock switches look similar. When using these
interlock switches adjacently, ensure that the heads are not
interchanged.
HS5B
Plastic Head
Metal Head
Plastic
(black
or gray)
The HS5E metal head can be distinguished easily with the black
plastic part (HS5E metal head has gray plastic part).
Rotating the Head
The head of the HS5E can be rotated by removing the four
screws from the corners of the HS5E head and reinstalling
the head in the desired orientation. Before wiring the HS5E,
replace the head if necessary. Before replacing the head, turn
the manual unlock to the UNLOCK position using the manual
unlock key. When reinstalling the head, make sure that no
foreign object enters the interlock switch. Tighten the screws
tightly, without leaving space between the head and body,
otherwise the interlock switch may malfunction.
Recommended tightening torque: 0.9 to 1.1 N·m.
Factory Setting
HS9Z-SH5
Sliding Actuator
Door
HS5E
Metal Head
Metal
(silver color)
∗
black ∗
(gray)
Head can be rotated.
HS5E
Flush
Silhouette
Switches &
Pilot Lights
Display
Lights
LED
Illumination
Units
Display
Units
Safety
Products
Terminal
Blocks
Comm.
Terminals
AS-Interface
Relays &
Timers
Sockets
Circuit
Protectors
Power
Supplies
PLCs &
SmartRelay
Operator
Interfaces
Sensors
Control
Stations
Explosion
Protection
References
717
Advertisement
