Operating The Camera From A Pc - Panasonic DC-BGH1 Operating Instructions Manual

Operating the Camera from a PC

Connect the camera and PC with a USB connection cable, LAN cable or Wi-Fi.
● When connecting the camera directly to a PC with a USB connection cable or LAN cable, you can connect to "LUMIX
Tether" with the default setting. Proceed to step 2. (Operate from step 1 if you change the default setting of [LAN / Wi-Fi]
or [USB Mode] in the [Setup] ([IN/OUT]) menu.)
● When connecting with Wi-Fi, output the camera menu screen via HDMI/SDI to an external monitor etc. (
Connecting the external
A
A [LAN] terminal
[USB] terminal
B
LAN cable (commercially available) or
C
PC (commercially available)
E
● Plug in/out straight holding onto the plug. (Inserting these at an angle may cause deformation or malfunction)
● Do not connect the cable to the wrong terminals. This may cause a malfunction.
Preparation:
● Turn on the camera and PC.
Install "LUMIX Tether" on PC.
●
12. Remote Operations - Tethered Recording
monitor)
B
USB connection cable (commercially available)
D
C
D
- 208 - - 208 -
27 /
E