Panasonic DC-BGH1 Operating Instructions Manual page 150

Switching the Card to Display
Images are displayed separately by card slot. When you press [Q.MENU] during playback you can switch the card that will be
displayed.
Use the Fn button registered with [Card Slot Change] to operate. In default settings, this is registered in [Q.MENU].
●
– About Fn buttons (
Press [Q.MENU].
Press to select [Card Slot 1] or [Card Slot 2] and then press [MENU/SET].
● The camera can playback videos in MP4 and MOV formats.
● Video recorded with a [System Frequency] setting that is different to the current one cannot be played back.
● When it is output via HDMI and SDI at the same time, it can be output with the same resolution. When [SDI Output] is set
to [ON] at [HDMI / SDI Connections] of the [Setup] ([IN/OUT]) menu, output with a resolution above 4K is not possible.
When playing back an image at a resolution above 4K, set the [SDI Output] to [OFF].
● High resolution audio cannot be output during SDI output.
– When output only via SDI: It is down converted to [48kHz/24bit].
– When output via SDI and HDMI at the same time: It is down converted to [48kHz/24bit] or [48kHz/16bit] depending on
the capabilities of the HDMI connection device.
● Depending on the aspect ratio, gray bands may be displayed on the top and bottom or the left and right of images. You
can change the band color in [Background Color(Playback)] in [HDMI / SDI Connections] of the [Setup] ([IN/OUT]) menu.
( 195 / [Background
● Change the settings of your external device if images are displayed with the top or bottom cut off.
● Also refer to the operating instructions for the external device.
9. Playback - Playing Back Videos
154 / Fn Buttons)
Color(Playback)])
- 150 - - 150 -