RightAngle NewHeights Electric Height Adjustable Conference Table Instructions page 3

K&A MANUFACTURING
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
VERSION DATED: 12/3/12
MOTOR WIRE
CONTROL BOX
WIRIING DIAGRAM
M3
M2
M1
HS
HAND SWITCH WIRE
ON FRONT CONTROL
BOX ONLY MOTOR WIRE
STEP 10: RUN THE WIRES AS SHOWN IN THE WIRE RUNS DIAGRAM BELOW. PLUG THE WIRES INTO THE
RECEPTACLES ON THE CONTROL BOXES AS SHOWN IN THE CONTROL BOX WIRING DIAGRAM BELOW LEFT.
RUN THE SYNCH WIRE BETWEEN THE CONTROL BOXES AND PLUG IT INTO THE TOPS OF THE CONTROL
BOXES.
STEP 11: WITH THE HELP OF AN ASSISTANT, SET THE TABLE UPRIGHT IN ITS FINAL POSITION. LEVEL THE
TABLE IF REQUIRED BY TURNING THE LEVELING GLIDES CLOCKWISE (FROM THE TOP) ON THE LOW
CORNERS OF THE UNIT. IF YOUR TABLE HAS CASTERS, TURN THE BOLTS AT THE TOPS OF THE CASTERS
TO LEVEL THE UNIT.
LEVELING GLIDE
(OR CASTER)
MOTOR MOTOR
WIRE WIRE
HAND
SWITCH
WIRE
HAND
SWITCH
WIRE
MOTOR
WIRE
CROSS SUPPORTS NOT SHOWN ON
THIS VIEW SO OTHER COMPONENTS
ARE VISIBLE.
HAND
SYNCH
SWITCH
WIRE
WIRE
MOTOR
WIRE
MOTOR
WIRE
110 VOLT 110 VOLT
POWER POWER
CORD CORD
WIRE RUNS DIAGRAM
110 VOLT POWER SUPPLY
(NOT INCLUDED)
MOTOR
WIRE
MOTOR
WIRE
POWER STRIP &
110 VOLT
SUPPLY (NOT
INCLUDED)
MOTOR
WIRE
110 VOLT POWER CORDS
FROM CONTROL BOXES
PAGE 3 OF 4