RightAngle NewHeights Electric Height Adjustable Conference Table Instructions page 2

K&A MANUFACTURING
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
VERSION DATED: 12/3/12
4
3
STEP 6
1
WORKSURFACE SUPPORT
STEP 6: ATTACH THE WORKSURFACE SUPPORTS ON THE COLUMN ASSEMBLIES 4 TO THE WORKSURFACE 1 USING
(24) WOOD SCREWS 3 . DO NOT OVER-TIGHTEN THE SCREWS. USE A LOW TORQUE SETTING ON THE DRILL.
STEP 7: ALIGN THE HOLES IN ONE OF THE CONTROL BOXES 9 WITH THE PILOT HOLES IN THE WORKSURFACE 1 .
THE MULTIPLE CONNECTOR PORTS MUST FACE THE COLUMN ASSEMBLIES 4 .ATTACH IT WITH (2) WOOD SCREWS 3 .
REPEAT THIS STEP WITH THE OTHER CONTROL BOX.
STEP 8: ALIGN THE HOLES IN THE HAND SWITCH 10 WITH THE PILOT HOLES IN THE WORKSURFACE 1 . ATTACH IT
WITH (2) WOOD SCREWS 3 .
STEP 9: ATTACH THE WIRE MANAGEMENT J 11 TO THE WORKSURFACE 1 USING (1) WOOD SCREW 3 . NO PILOT
HOLE IS PROVIDED FOR THE WIRE MANAGEMENT J.
3
10
3
9
3
3
11
CROSS SUPPORTS NOT SHOWN ON
THIS VIEW SO OTHER COMPONENTS
ARE VISIBLE.
STEPS 7-9
PAGE 2 OF 4