Download
Share
Print this page
  1. Manuals
  2. Brands
  3. RightAngle Manuals
  4. Indoor Furnishing
  5. NewHeights Series
  6. Instructions

RightAngle NewHeights Series Instructions

Hide thumbs Also See for NewHeights Series:
1
2
3
4
5

Advertisement

Quick Links

Download this manual
K&A Manufacturing
6703 Zinser Street
Schofield, WI 54476
Phone: 800.298.4351
Fax: 866.882.9475
www.raproducts.com
11/13/14
NewHeights™ Series 4 LT
Efficiente 3-Leg Instructions
to Replace Leg Spindles
Read all the instructions before beginning.
Page1 OF 5
Hardware Pack # 53419
Instruction # 53418

Advertisement

loading
Need help?

Need help?

Do you have a question about the NewHeights Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for RightAngle NewHeights Series

Summary of Contents for RightAngle NewHeights Series

  • Page 1 K&A Manufacturing 6703 Zinser Street Schofield, WI 54476 Phone: 800.298.4351 Fax: 866.882.9475 www.raproducts.com 11/13/14 NewHeights™ Series 4 LT Efficiente 3-Leg Instructions to Replace Leg Spindles Read all the instructions before beginning. Page1 OF 5 Hardware Pack # 53419 Instruction # 53418...
  • Page 2 K&A Manufacturing 6703 Zinser Street Schofield, WI 54476 Phone: 800.298.4351 Fax: 866.882.9475 www.raproducts.com Your workstation will have (2) left legs and (1) right leg. Below shows how to identify which legs are left or right. After replacing the spindles, make sure to reassemble the workstation as it was originally.
  • Page 3 Step 1: Unplug the power cord for the control box. Lay the leg assembly 1 on its side on a protected surface. Remove (4) socket screws 2 and (4) K&A Manufacturing washers 3 holding the foot 5 onto the bottom of 6703 Zinser Street Schofield, WI 54476 the column.
  • Page 4 K&A Manufacturing 6703 Zinser Street Schofield, WI 54476 Phone: 800.298.4351 Fax: 866.882.9475 www.raproducts.com Left Leg Assembly Right Leg Assembly When looking When looking into the hex into the hex drive hole, you drive hole, you should see the should see the black part of orange part of the spindle.
  • Page 5 Step 2: Remove (4) socket screws 2 and (4) lock washers 3 holding the worksurface support and spindle assembly 6 onto the top of the inner extrusion. Remove the worksurface support and spindle from the K&A Manufacturing column. 6703 Zinser Street Schofield, WI 54476 Phone: 800.298.4351 Fax: 866.882.9475 www.raproducts.com...