Table of Contents
Advertisement
A.2
Directives and standards
Relevant directives and standards
The following directives and standards are relevant for the converters:
European Low Voltage Directive
The converters fulfil the requirements stipulated in Low Voltage Directive 2014/35/EU insofar
as they are covered by the scope of application of this Directive.
European Machinery Directive
The converters fulfil the requirements stipulated in Machinery Directive 2006/42//EU insofar
as they are covered by the scope of application of this Directive.
Use of the converters in a typical machine application has been fully assessed for
compliance with the main regulations in this Directive concerning health and safety.
European EMC Directive
By completely complying with IEC/EN 61800-3, it has been proven that the converter is in
compliance with Directive 2014/30/EU.
Underwriters Laboratories (North American market)
Converters bearing one of the certification marks shown on the left meet the requirements
for the North American market as a component of drive applications and are listed
correspondingly.
EMC requirements for South Korea
The converters with the KC marking on the rating plate satisfy the EMC requirements for
South Korea.
Eurasian conformity
The converters comply with the requirements of the Russia/Belarus/Kazakhstan customs
union (EAC).
Australia and New Zealand (RCM formerly C-Tick)
The converters bearing the certification mark shown here meet the EMC requirements for
Australia and New Zealand.
Specification for semiconductor process equipment voltage drop immunity
The converters comply with the requirements of standard SEMI F47-0706.
Quality systems
Siemens AG employs a quality management system that meets the requirements of ISO
9001 and ISO 14001.
Power Module PM240P-2
Hardware Installation Manual, 06/2020, A5E37800827C AD
Appendix
A.2 Directives and standards
97
Advertisement
Table of Contents
