Issue a boot command.
See the section \Booting the Workstation" for details.
o the workstation. There is no need to shut down the workstation
Turn
with the special procedure described in Chapter 3, since the workstation has
not yet been booted, and the le system has not been activated.
Getting Help for the Boot Console User Interface Commands
You may issue many dierent commands in the boot administration mode. For
a complete listing, at the
h
4
5
Return
help
4
5
Return
?
4
5
Return
To get help for a particular command, type the following at the
prompt:
command name
help
command name is the name of one of the listed commands.
where
The displayed help information usually includes a description of the command,
its options, and the format for parameters.
Booting the Workstation
Usually, you start your workstation in Normal Mode by turning it on and
waiting for HP-UX to boot automatically. However, you may not want the
usual sequence to occur.
For example, you may want to start your workstation from an operating system
that is stored on a device that is dierent from your usual boot device. If
your normal operating system kernel or the disk on which it resides becomes
damaged or unusable, you may wish to boot from a dierent disk or perhaps
another type of device, such as a DDS-format tape drive.
DRAFT
2/5/97 11:31
prompt type one of these commands:
BOOT_ADMIN>
4
5
Return
BOOT_ADMIN>
Using the Boot ROM
C
C-5