Setting the VME Backplane Networking Parameters
The boot-administration
VME backplane networking parameters: the CPU number on the backplane,
the backplane anchor address, and the backplane anchor AM code. To display
this information, type the following at the
bpn_config
The CPU number, backplane anchor address, and AM code will be printed as
in the example below:
Current configuration:
CPU No. 0
Anchor 0x00200000
AM code 0x3d
The values given above are also the default values for these models of the Series
700i.
To change the VME conguration CPU number, Anchor, or AM code, you will
need to change the position of the Service/Normal switch to \Service". (This
can be done without restarting the boot sequence or exiting the Boot Admin
mode.) Then enter the numbers to be changed after the
in the following order:
CPU number
1.
Anchor number
2.
AM code
3.
To obtain help with this command, type
DRAFT
2/5/97 11:31
command allows you to congure the
bpn_config
BOOT_ADMIN>
help bpn_config
prompt:
command,
bpn_config
.
Using the Boot ROM
C
C-15