Omcan IC-CN-0060 Instruction Manual page 10

Installation
• Attach the free end of inlet hose to the water supply tap. Hand tighten sufficiently to provide leak free joint.
It is advisable to have the stop valve within easy reach.
• Hand tighten flexible water hose onto the fitting on the rear of ice maker as indicated, confirm whether the
sealing ring has been tightened in the right position to avoid leaking at joints. The pipe can be cut to length
as necessary to suit position of main drain. To prevent water leaks, secure.
BEFORE ICE MACHINE START
All ice machine adjustment have been factory pre-set before shipment.
Adjustment to program or setting is not required for new ice machine installation.
In order to make sure that ice machine operate normally, please refer to the operation section of service
manual. Checking and monitoring of Ice machine operation is the responsibility of users.
PRE-INSTALLATION CHECKLIST
• Is ice machine installed on a horizontal leveled surface?
• Is ice machine water pipe installed correctly?
• Have all inner packaging and accessories been removed?
• Is water supply, drain and electricity connected properly?
• Is power supply voltage matching with the specified voltage on rating plate?
• Have users/operator filled in the warranty card?
• Is there proper ventilation around ice maker for good airflow?
• Is ice machine and storage bin disinfected?
• Is ice machine grounded correctly?
• Is power switched on?
• Is ice machine located at ambient temperature between 10°C to 43°C?
• Is the inlet water temperature between 8°C to 32°C?
• Has the user / operator read this Use and Service Manual.
10