Table of Contents
Advertisement
Maintenance
Do not cover the headlight or lens with
any item likely to obstruct air flow to,
or prevent heat escaping from, the
headlight lens.
Covering the headlight lens during
operation
with
luggage,
adhesive
intended
to
alter
headlight
beam
headlight lens covers will cause the
headlight lens to overheat and distort,
causing irreparable damage to the
headlight assembly.
Damage caused by overheating is
not
considered
defect and will not be covered under
warranty.
If the headlight must be covered
during use - such as taping of
the headlight lens required during
closed-course
headlight must be disconnected.
184
Caution
items
of
clothing,
tape,
devices
or
adjust
or
non
genuine
a
manufacturing
conditions
-
Headlight Adjustment
The vertical beams of the left and right
hand headlights can only be adjusted
together. Independent adjustment is
not possible.
the
1.
Headlight bracket bolts
2.
Front subframe alignment marks
3.
Headlight bracket mark
To vertically adjust the headlights:
•
Switch the ignition on. The engine
does not need to be running.
the
•
Switch the headlight dipped beam
on.
•
Loosen the two headlight bracket
bolts securing the headlight bracket
to the front subframe sufficiently
to allow restricted movement of the
headlights.
•
Using the headlight bracket mark
and the alignment markings on
the front subframe, adjust the
position of the headlights to give
the required beam setting. Each
alignment mark on the subframe
represents 1°.
•
Moving
forwards
upwards.
bracket
headlights downwards.
1
the
headlight
moves
the
headlight
Moving
the
headlight
rearwards
moves
2
3
bracket
the
Advertisement
Chapters
Table of Contents
