Triumph Street Triple S 660 cc Owner's Handbook Manual page 142

Maintenance
The engine oil and engine oil filter
must be replaced in accordance with
scheduled maintenance requirements.
2
1
cjxt
1. Oil drain plug
2. Oil filter
To change the engine oil and engine oil
filter:
• Warm up the engine thoroughly,
and then stop the engine and
secure the motorcycle in an upright
position on level ground.
• Place an oil drain pan beneath the
engine.
• Remove the oil drain plug.
• Unscrew and remove the oil filter
using Triumph service tool T3880313.
Dispose of the old oil filter in an
environmentally friendly way.
• Apply a thin smear of clean engine
oil to the sealing ring of the new oil
filter. Fit the oil filter and tighten to
10 Nm.
• After the oil has completely drained
out, fit a new sealing washer to the
drain plug. Fit and tighten the drain
plug to 25 Nm.
142
• Fill the engine
or fully synthetic
10W/50 motorcycle
which meets specification API SH
(or higher) and JASO MA, such as
Castrol Power 1 Racing 4T 10W-40
(fully synthetic) engine oil, sold as
Castrol Power RS Racing 4T 10W-40
(fully synthetic) in some countries.
• Start the engine and allow it to idle
for a minimum of 30 seconds.
Raising the engine speed above idle,
before the engine oil reaches all
parts of the engine can cause engine
damage or seizure.
Only raise engine speed after running
the engine for 30 seconds to allow the
engine oil to circulate fully.
If the engine oil pressure is too low,
the low oil pressure warning light will
illuminate. If this light stays on when
the engine is running, stop the engine
immediately and investigate the cause.
Running the engine with low oil
pressure will cause engine damage.
• Make sure that the low oil pressure
warning light remains off and the oil
pressure message is not shown in
the instrument display screen.
• Stop the engine and recheck the oil
level. Adjust if necessary.
with a
10W/40
engine
Caution
Caution
Semi
or
oil