Installing The Teaching Pendant (T/B); Turning On The Control Power - Mitsubishi Electric melfa RV-5AS Instruction Manual

2.3.1 Installing the teaching pendant (T/B)

Installing the T/B, with turning off the controller power.
CAUTION
Explain the installation method of T/B below.
1) Check that the controller's power supply is OFF.
2) Refer to Fig. 2-7
Use as the upper surface the lock lever, and push in until there is sound.
3) Pressing down the lock lever to lock the connector as shown below.
Teaching pendant (T/B)
Fig. 2-7: Installing the T/B

2.3.2 Turning ON the control power

CAUTION
1) Turn the controller power switch ON.
Turns ON the switch of the earth leakage breaker of installation outside.
Please do not pull the cable of T/B strongly or do not bend it too much.
It becomes the breaking of a wire of the cable and the cause of breakage of the
connector. Please installing so that stress does not start the cable with the con-
nector itself.
and connect T/B connector to the robot controller.
T/B connection connector
Confirm that there are no operators near the robot before turning the power ON.
A
TB connector
Lock lever
2 Unpacking to Installation
Details of A section
Pressing down the lock lever to
lock the connector.
Confirming the operation 2-15