Table of Contents
Advertisement
b. If you select Tagged or DQTagged, the
values are 1 - 4079. The default is 6. Enter the P-bit type. Options are 0 - 7. The default is 0.
c. If you select DQTagged, the
will be accepted and mapped to the specified WAN. Valid values are 1 - 4062. The default is 0.
4. In the
IPV4 CONFIGURATION
IPv4 WANs", or "PPPoE for IPv4 WANs".
5. In the
IPV6 CONFIGURATION
Address for IPv6 WANs".
Cross-Connect Settings
On this tab, you can configure bridge settings for traffic moving from a WAN-side VLAN to a LAN port. This can be used for bridged
IPTV or other services.
1. In the left menu, click
2. Click the
CROSS-CONNECT
3. Configure the tagging options:
a. In the
Tag Mode
DQTagged. The default is Tagged.
b. If you select Tagged or DQTagged, the
values are 1 - 4079. The default is 6. Enter the P-bit type. Options are 0 - 7. The default is 0.
c. If you select DQTagged, the
will be accepted and mapped to the specified WAN. Valid values are 1 - 4062. The default is 0.
4. Click
APPLY
to save and apply your changes.
SmartRG Inc., an ADTRAN Compny Proprietary and Confidential. All Right Reserved. © 2019
VLAN
CVID
field also appears. Enter the Customer VLAN ID or the first in a range of CVIDs that
section, configure the settings using the information in "DHCP for IPv4 WANs", "Static Address for
section, configure the settings using the information in "DHCPv6 for IPv6 WANs" and "Static
Network
>
Ethernet
WAN. The following page appears, showing the
tab. The following page appears.
field, select the type of tagging that should be performed. Options are Untagged, Tagged, and
VLAN
CVID
field also appears. Enter the Customer VLAN ID or the first in a range of CVIDs that
and
P-bit
fields appear. Enter the ID of the appropriate VLAN. Valid
and
P-bit
fields appear. Enter the ID of the appropriate VLAN. Valid
INTERNET
tab.
21
Hide quick links:
Advertisement
Table of Contents
