Agilent Technologies FieldFox N9923A User Manual page 22

A 3-trace configuration. Tr2 is the ACTIVE trace as indicated by the highlighted
Trace Setting Notes
 The Frequency Range, IF BW, Resolution, Average, and Output Power settings
 All other trace settings, such as measurement, format, and limit lines, are
 By default, a marker is created on ALL traces as show in the above image.
How to select a multi-trace configuration
 Press Trace 6
 Then
 Then choose from the following:
How to activate a trace in order to change a setting
 Use the ▲|▼ arrows OR
 Press Trace 6 then select
22
are common for all displayed traces.
applied individually to the ACTIVE trace in the same manner as when a single
trace is present.
However, they can be created individually by disabling Coupled Markers.
Learn more on page 78.
Num Traces
Default measurements shown in (parenthesis) depend on the options that are
installed.
1 trace standard configuration (S11)
x1
2 traces overlayed on a single graticule (S11, S21)
x2
x2H 2 traces on separate horizontal graticules (S11, S21)
3 traces on separate horizontal graticules (S11, S21, S12)
x3H
4 traces on separate graticules (S11, S21, S12, S22)
x4
that are shown can be activated.
Trace 1, Trace 2, Trace
Tr 2
3, or Trace 4, Only traces
N9923A FieldFox User's Guide