How to maximize the viewing of the active trace
Press System 7
Then
Press any key to return to the standard display.
Quick Settings
Both NA and CAT Modes allow you to view and change most relevant settings
from a single location.
The Quick Settings menu. The resolution is being edited.
NOTE
Interference Rejection and System Z0 can be changed ONLY from the Quick
Settings menu. Learn more about these settings on pages 29 and 29. ALL other
settings can also be made using the standard softkey menus.
How to view and change Quick Settings
Press Meas Setup 4.
Then Settings.
Press
To change a setting:
Format
Select the display format in which to present measurement results.
NA (Network Analyzer) Mode
Full Screen
and
Next Page
Previous Page
NOT available, then all available settings fit on one page.
Use the ▲|▼ arrows to highlight a setting.
o
Then press Edit. The current setting changes to
o
Some settings require you to press a softkey to change the value. Otherwise,
o
use the numeric keypad, ▲|▼ arrows, or rotary knob to change the value.
When finished changing a value, press
o
When finished changing settings, press Done.
o
to view all settings. If these softkeys are
yellow
.
Done
Edit.
23