Data Analysis Features
The following features can be used to analyze NA and CAT mode measurement
results.
In this Chapter
All about Markers
Markers move along the X-axis range of the measurement trace to provide a
numerical readout of each measured data point. Markers also allow you to search
for specific Y-axis values.
A trace can contain up to six markers.
The marker readout on the FieldFox shows X and Y-axis information for the
active marker ONLY.
A Marker Table can be displayed that allows you to simultaneously view X and Y-
axis information for all markers.
Markers can be used in CAT, SA, and NA Modes.
How to create Markers
Press Marker .
Then
Then
Then move the marker using the rotary knob, the ▲|▼ arrows, or by entering
Then press Enter.
How to move a Marker after it is created
Press Marker .
76
Marker Table .................................................... 78
Marker Trace.................................................... 79
Marker Format ................................................ 80
to select a marker to activate.
Markers 1...6
to activate that marker. A marker is created on the trace in the
Normal
middle of the X-axis. That marker is now active.
an X-axis position with the number keys.
N9923A FieldFox User's Guide