G
ETTING STARTED
Backlight
The display includes a backlight which illuminates the display for 10 seconds
after any key is pressed and during measurements. Switch the backlight on or
off as required. Switching the backlight off will increase battery life.
MENU / BACKLIGHT
3.6 Selecting a language
Your Covermeter has a number of built-in
languages. When the Covermeter is switched
on for the first time after dispatch from the
Elcometer factory the display will show the
language selection screen (Figure 7).
At first switch on
1. Press
or
required.
2. Press
to activate the selected language.
The Covermeter operates in the new language until changed.
At any time
1. Switch Covermeter off.
2. Press and hold left hand softkey.
3. Press
to switch on Covermeter.
The display will show the language selection screen with the current
language highlighted by the cursor.
4. Release left hand softkey.
5. Press
or
6. Press
to activate the selected language.
Alternatively, select a language at any time.
MENU / SETUP / LANGUAGE
3.7 Computer interface
Your Covermeter is fitted with an RS232 interface. The interface is located
under the interface access cover at the rear of the Covermeter - see Figure 2
and Figure 3 on page 5.
12
R
to locate language
to locate language required.
Figure 7. Language
selection screen