General - Siemens SINUMERIK 802C base line Technical Manual

Start-Up
4.1

General

Start–up requirements
Start–up sequence
SINUMERIK 802C base line
Start-Up
The following is required:
z
 User Manual: Operation and Programming, SINUMERIK 802C base
line
 PC/PG (programming device) only for data saving and series start–
up
 Toolbox on CD. The CD is either supplied with the control system or
can be ordered separately.
Contents
 WINPCIN for data transfer via the V24 interface from/to
external PC/PG
 Cycle pack Turning and Milling
The mechanical and electrical installation of the equipment must be
z
completed.
Notice
For installation refer to the installation notes provided in the section 2.
The control system with its components has powered up without errors.
z
The SINUMERIK 802C base line can be strated up as follows:
1. Check whether the ENC has powered up.
2. PLC start-up
3. Technology setting
4. Set general machine data.
5. Set axis/machine–specific machine data.
 Match encoder with spindle
 Match setpoint with spindle
6. Dry run for axes and spindle(s)
7. Drive optimization
8. Complete start-up, data saving
4
4-1