Making A Measurement - Keysight X Series Measurement Manual

Making a Measurement

Setting up a Click measurement
Step
1 Turn on the receiver
2 Test Set Up
3 Select the
Disturbance
Analyzer
measurement
Action
a. Press the front-panel power key.
a. Configure the Device Under Test
(DUT)
b. Connect the DUT power cable to
a Line Impedance Stabilization
Network (LISN)
c. Connect the LISN to the mains
power
d. Connect the output RF port from
the LISN to the N9038A MXE
EMI Receiver
e. Press Mode, EMI Receiver,
Meas, Disturbance Analyzer
(Click)
Disturbance Analyzer (Click) Measurements
Notes
This brings up the following Click
Measurement display.
29
Making a Measurement