McQuay MWSC 010 Series Manual page 47

Wired Remote Control
1. "ON/OFF" switch
ó Press to start the air conditioner unit.
ó Press again to stop the unit.
2. Temperature setting
ó Set the desired room temperature.
ó Press button to increase or decrease the set temperature. Setting range are between 16 °C to 30 °C (60 oF to 80
oF)
3. Operation modes
ó Press the "MODE" button to select the type of operating mode.
ó Cooling Only:
ó COOL, DRY, FAN
4. Fan Speed selection
ó Press the button until the desired fan speed is achieved.
5. Timer
ó Press the set button to select the switch timer of the air conditioner unit (the setting range is between 1 to 10
hours).
6. Sleep" mode
ó Press button to activate the sleep function. This function can only be activated under "cool" mode operation. When
it is activated under "cool" mode operation, the set temperature will increase 0.5°C after 30 minutes, 1 °C after 1
hour and 2 °C after 2 hours.
7. Air Swing
ó Press button to activate the automatic air swing function.
8. Sensor
ó Infra red sensor to receive signals from wireless controller.
9. LED display
ó To display the set temperature (in °C) and timer delay setting (in hours).
10. Transmission source
ó Source where the signal will be transmit from.
Page 46