McQuay MWSC 010 Series Manual page 36

STEP 2:
Position the hanger rods as shown in Figure B, and install the hanger bracket.
See Figure F.
STEP 3:
Hang up the unit and tighten the bolt. After completing the piping and draining pipe, install back the grille and panel.
See Figure G.
INSTALLATION-FLOOR STANDING TYPE
STEP 1:
Remove the air intake grille, side close-up and side panel from the unit. See Figure E.
STEP 2:
There are two types of piping and draining pipe connection, as shown in Figure H.
FIGURE F
FIGURE G
FIGURE H PIPING AND DRAIN PIPE INATALLATION
WALL
PIPING & DRAIN
PIPE FROM TOP
PANEL
WALL
OR PIPING & DDRAIN PIPE
FROM BACK PANEL
Page 35