Installation Of Outdoor Unit - McQuay MWSC 010 Series Manual

Split water source heat pump and cooling only unit
Table of Contents

Advertisement

Installation Of Outdoor Unit

The location of the outdoor unit is very fl exible, it can be installed in ceiling, stairs, toilet and out wall or other places.
In order to operate the unit reliable, precaution steps:
1) Leave enough space for service person to perform maintenance of repair and provide suffi cient room to make
water, electrical connections.
2) The place can withstand the weight of the outdoor unit and isolate the noise and vibration.
400mm
Barrier
3) If unit is suspended from the ceiling by four threaded rods. The rods are attached to the unit supportably by a
hanger bracket through a rubber isolator.
Caution : Do not use rods smaller than specifi ed above. The rods must be securely anchored to the ceiling
or to the bar joist.
Shockproofinsulator
Page 36
Water flow switch
500mm
Bolt
3/8" THREADED ROD
VIBRATION ISOLATOR
WASHER 3/8"
HEX NUTS
Barrier
Water filter

Advertisement

Table of Contents
loading

Table of Contents